Gateway E-9232T - Manual (Page 51)

www.gateway.com
45
8 Remove the seven screws securing the system board to the case.
9 Pull the system board away from the case and carefully remove it, then place it in a
static-free bag on a stable work surface.
10 Insert the new system board into the case, aligning the holes in the board with the threaded
standoffs on the side of the case.
11 Secure the system board to the case with the seven (7) screws you removed previously.
12 Reinstall the memory by following the instructions in “Installing memory” on page 34 .
13 Reinstall the processor and heatsink by following the instructions in “Replacing the
processor” on page 38 .
14 Connect the power and data cables.
15 Reinstall the expansion cards by following the instructions in “Installing PCI expansion
cards” on page 35 .
16 Follow the instructions in “Closing the server case” on page 24 .
17 Turn on your server.
18 Press F2 when the Gateway logo screen appears during startup. The BIOS Setup utility
opens.
19 Check BIOS settings to make sure that they detect the server’s new hardware, then save
your changes (if any) and close the BIOS Setup utility.
Screw Screw
Screw
Screw
Screw
Screw
Screw