Genicom PC4 User Manual
Page 36
24
EasyCoder PC4 User’s Guide
Chapter 3 — Operation
5
Place the roll and spindle in the media compartment and snap the
spindle into the slots on either side.
6
Wind the green edge guide wheel towards the rear of the printer so
the rear edge guides just touch the media roll without actually break-
ing its rotation.
7
Thread the labels through the slits in the front edge guides.
8
Route the media through the slot in the optional cutter mechanism
just in front of the tear bar.
9
Firmly close the top cover.
10
If loading media for the first time or if changing from another type or
size of media, perform a Label Gap Sensor Adjustment as described
on page 28. Else, tap the Feed key either 4 times or until the indicator
lamp glows green.
11
If the printer did run out of media while printing, the printing will
automatically be resumed.