Memory cartridge – Genicom PC4 User Manual
Page 20
8
EasyCoder PC4 User’s Guide
Chapter 2 — Installation
Memory Cartridge
The EasyCoder PC4 is fitted with 1 MB built-in flash memory and 2
MB DRAM. The built-in memory can be expanded using an exchange-
able memory cartridge with 1MB of Flash memory.
When fitting or removing a memory cartridge, the power to
the printer must be off!
Installation of Memory Cartridge
1
Ensure that the On/Off switch on the printer is off (0).
2
Open the top cover by pressing the two locks on either side.
3
Remove the cartridge slot cover located to the left of the media roll.
Be careful not to drop it inside the printer.
4
Ensure that the switch at the front short side of the cartridge is in its
lower position.
5
Insert the memory cartridge into the cartridge slot. Its slightly curved
shape ensures that the cartridge can only be fitted correctly. Push
firmly to seat the cartridge.
6
Firmly close the top cover and switch on the power.
Insert memory
cartridge
Memo
ry
Car
trid
ge
Switch down