Furuno 1715 - Manual (Page 33)

3. INSTALLATION
25
Mounting plate
Support
plate (1)
Support
plate (2)
Bracket (1)
Bracket (2)
Fixing plate
M8 x 20
M8 x 20
(A) Assembling the mounting bracket
M4 x 12
(B) Fastening antenna to mounting bracket
M10 x 25
M8 x 20
How to assemble the optional mounting
bracket and mount the antenna
4. Open the cover.
5. Follow steps 5-13 in “Mounting on a
platform.”
3.2 Display Unit Installation
Mounting considerations
When choosing a mounting location for the
display unit, keep in mind the following points:
• Keep the display unit out of direct sunlight.
•
The temperature and humidity should be
moderate and stable.
•
Locate the unit away from exhaust pipes
and vents.
• The mounting location should be well
ventilated.
•
Mount the unit where shock and vibration
are minimal.
•
Keep the unit away from electromagnetic
field-generating equipment such as motors
and generators.
• For maintenance and checking purposes,
leave sufficient space at the sides and rear
of the unit and leave slack in cables.
•
Separate the display unit from a magnetic
compass unit by the distances noted below
to prevent interference to the magnetic
compass:
Standard compass: 0.60 m
Steering compass: 0.40 m
•
Be sure the mounting location is strong
enough to support the weight of the unit
under the continued vibration normally
experienced on the boat.
Mounting
The display unit can be mounted on a
desktop, overhead or bulkhead, or flush
mounted in a console.
Desktop, overhead mounting
1. Fix the hanger to the mounting location
with four tapping screws (supplied).
2. Fit the knob bolts to the display unit.
3. Set the display unit to the hanger.
4. Tighten the knob bolts securely.
Flush mounting
Cutout a hole in the mounting area, referring
to the template provided. Fasten the display
unit with four screws (M4 x 20, supplied).
Bulkhead mounting
Using the template sheet provided, make four
holes (Φ4.5) in the mounting location to fix
the hanger.