3 loading documents – FUJITSU SCANSNAP! FI-4110EOX2 User Manual

Page 40

3.3

Loading Documents

This section describes how to load documents on the document support.

1. Straighten the edges of the document.

1) Straighten both sides of the document stack.

2. Fan the documents

1) Take out the stack of documents of thickness 4 mm or less.

• A number of sheets A4/Letter or smaller in size up to 4 mm (50 sheets of 64 g/m

(17 lb) paper)

2) Hold both ends of the document with both hands, and bend the documents into an

arch.

3) Firmly holding the document with both hands, bend back the document as follows

so that the bent section rises up in the middle of the document.

4) Repeat steps 1) to 3) a few times.
5) Hold the other two sides of the document, and fan again.

3. Load the document on the hopper.

Load the document as follows.

■ When loading the document so that both sides are scanned

Load the document so that the top side of the two-sided document (in the case of two or
more document sheets, the first page) is towards the ADF paper chute.

4mm