Fostex FD-8 - Manual (Page 78)

MIDI Synchronization
78
1. Set the channel 1-8 INPUT SEL switches to [TRK].
2. Set the SELECTOR in the monitor section to
[L/R+MON].
3. Raise the master faders L/R to [7-8].
4. Connect the MON OUT (L/R) jacks and the
RECORDER IN jacks directly.
This connection will route the L/R+MON signals output
from MON OUT (L/R) to the DAT OUT jacks via the
RECORDER IN jacks for mixdown. (The L/R+MON signals
include the playback signals from tracks 1-8 and eight
MIDI sound sources.)
5. Set the “Setting digital output tracks” in SETUP
mode to [L- , r- ].
• See page 110 for more information.
4
3
2
1
6
6
7
8
Mixing down while syncing MIDI sound sources
When you finish overdubbing, proceed to mixdown. As shown in the diagram, use the connected MIDI sound
sources as virtual tracks, synchronize them to the FD-8, and mix down digital signals while applying effects.
6. Use the input channel faders and the PAN knobs to
adjust the playback levels and stereo image of
tracks 1-8.
Turn the MON knob in the MON mix section of the
corresponding channels toward [INPUT] to adjust the
input level of the MIDI sound sources, and use the MON
PAN knob to adjust the stereo image.
7. Use the MASTER knob in the monitor section to
adjust the final output level for mixdown.
8. If you wish to apply effects to a track, turn the AUX
knob and AUX RTN knob of the corresponding
channel to adjust the effect amount and balance.
POWER
R MON OUT L R ST OUT L AUX RTN 2 R MONO/L 2 AUX SEND 1
SCSI OUT IN DATA PUNCH
IN/OUT DATA
AUX RTN 1 R MONO/L 8 INSERT 7
INPUT 8 INPUT 7
R RECORDER IN L IN MIDI
OUT MIDI
MIDI
Sequencer
MIDI sound sources
Digital Master Recorder
Effect Unit 1
Effect Unit 2
POINT!