FOCUS Enhancements FS-C - Manual (Page 87)

FS-C Functions
FS-C Portable DTE Recorder 71
TC SET
The Timecode Set parameter stores a user defined timecode in
the
FS-C’s non-volatile memory. This value is available for use by
the FS-C immediately after exiting
TC SET
.
• TC FREE RUN
The FS-C uses this value on the next recording after it is
set in
TC SET
.
• TC REGEN
This is the starting value when using an empty hard
disk drive for recording.
• TC REC RUN
This is the value used to begin every recording session
after a power cycle.
The TC SET value is only actively applied when the unit is in
DV RECORDER mode.
TC SET
00 : 00 : 00 : 00
HH : MM : SS : FF
BACK