FUJITSU PLASMAVISION PDS4229W - Manual (Page 35)

34
* On-screen information disappears if you do not take any action for about 60 seconds.
* The following abbreviations used in this document represent input modes in which you can make adjustments:
: Video mode, : S-video mode, : Comp.video mode, : RGB-PC mode, : Decoder mode
• Assigning Numbers to Displays (Monitor No.) All modes
When you use two or more displays, you can use a single remote control to control individual
displays by assigning a unique number to each of the displays.
Each time you press or , one of the available numbers appears in the following sequence:
0: You can normally control displays.
You cannot control displays if you press any of [SHIFT 1] through [SHIFT 4].
1–4: Allows you to control a desired display by pressing the corresponding button (one of
[SHIFT 1] through [SHIFT 4]).
When you do not press any of the SHIFT buttons, you can control all displays.
Press to store.
* You can check the “Monitor No.” on the Information screen.
• Setting RGB Input Signal Compulsorily (Direct Setting)
You can use this option to switch the setting for RGB input signal.
Each time you press or , one of the available choices appears in the
following sequence:
Auto: Automatically displays the input signal to the optimum.
VGA: Fixes the setting for the optimum resolution for VGA.
WVGA: Fixes the setting for the optimum resolution for WVGA.
480P: Fixes the setting for the optimum resolution for 480P.
XGA: Fixes the setting for the optimum resolution for XGA.
Press to store.
* In Auto mode, the resolution of VGA, WVGA, 480P and XGA may not be automatically
distinguished. Switch to the fixed display when the image is not displayed properly.
• Specifying RGB Input Signal Directly (Code Setting)
You can use this option to specify and display the type of RGB input signal directly.
Each time you press or , one of the available choices appears in the following
sequence:
Auto Manual
Auto: Automatically displays the input signal to the optimum.
Manual: Selects RGB code number.
Press to store.
* In Auto mode, the optimum resolution may not be set up automatically depending on the type of
signal.
Select the type of signal when the image is not displayed properly.
However, note that when the type of signal is selected directly, the signal of other resolution may
not be displayed properly.
• Displaying white over entire screen (White screen) All modes
You can use this option to display white over the entire screen, so that brightness adjustments can be
performed to minimize phosphor burn-in.
Each time you press or , one of the available choices appears in the following sequence:
On Off
Off: Does not display white.
On: Displays a white screen immediately.
Press to execute.
"Code Setting" setting screen
OTHER ADJUSTMENTS (FEATURES MENU)(Continued)