FUJITSU ErgoPro m664 - Manual (Page 86)

ErgoPro m664 PC Specialist's Handbook
Page 9-4 Edition 1 - Release 1 - March 1998
Architecture & Configuration of m664-series
m664/233, m664/266, m664/300, m664/333
Chip set Intel 440LX AGPset (i.e. 82443LX and 82371AB)
Memory banks 3, with SDRAM support
SIMM modules per
bank Not available
DIMM modules per
bank 1
BIOS 256 kB (i.e. 2 Mb) Boot Block Flash RAM, Intel/Phoenix platform with PnP
(1.0A), ACPI (1.0) and PCI (2.1) support
Keyboard controller Industry standard (AMI), built-in PC97307
Theft prevention No
Power Management Yes, APM rev. 1.2 compliant (Windows 95), ACPI 1.0 compliant (future
Windows 9x)
Desktop Management Yes, DMI 2.0
Floppy drive Yes, a place for one 3.5” floppy drive, BIOS support: 720kB, 1.44MB and
2.88MB (3.5"), 360kB and 1.2MB (5.25")
Architecture /
Expansion slots Slots on the system board:
one AGP (32-bit),
three PCI (32 bit),
one shared PCI/ISA (32 bit / 16 bit),
two ISA (16-bit)
Mass memory bays A 3.5” device bay for three 3.5” devices (one of them occupied by Floppy
drive), two devices attached to the 3.5” bay are front accessible.
A 5.25” device bay for three 5.25” or 3.5” devices. Attaching the 3.5” device to
the 5.25” bay requires rails (not supplied by Fujitsu). All devices attached to the
5.25” bay are front accessible.
HD silencer No
Power supply 235 W ATX-style, 110/240 V, 48 Hz to 63 Hz, Power Supply Unit has a
monitor outlet connector
Fans Two temperature controlled fans, one in front panel (air in to the housing),
another one in the PSU (air out from the PSU/housing).
Dimensions
Width 190 mm
Heigth 440 mm
Depth 480 mm
Weigth 13 kg (approx.)