FUJITSU ErgoPro m664 - Manual (Page 65)

PC Specialist's Handbook ErgoPro m664-series
Edition 1 - Release 1 - March 1998 Page 6-5
3D
· 1M Triangle/s Setup-Engine
· 4 kB on-chip texture (cache)
· 16-bit Z-buffering
· Single-pass trilinear filtering
· Perspective correct mip-mapping
· Video texturing
· Goraud and Specular Shading
· Alpha blending
· Fog
· Edge anti-aliasing
· Texture lighting
· Sub-pixel and sub-texel accuracy
ATI 3D Charger PCI add-on board (AF31552)
ATI 3D Charger, based on ATI ‘3D RAGE II +DVD’, 64-bit 3D graphics engine with 2 MB EDO RAM (40 ns), is
an PCI based graphics accelerator adapter (5 V, Bus Master device).
The amount of the EDO RAM can be upgraded up to 4 MB with an optional 2 MB EDO RAM memory expansion
modules (40 ns). The RAMDAC, which has 64-bit data path to the EDO RAM, can handle pixel frequencies up
to 170 MHz. The video interface is DDC1, DDC2B+ and VESA DPMS compatible. The adapter has an AMC
connector (v. 2.0). ). The adapter has the INTERRUPT ENABLED/DISABLED jumper. As a default the jumper
is in the DISABLED position, i.e. the adapter does not reserve an interrupt. Main features:
H/W Video Acceleration
· Video scaling
· YUV to RGB color space conversion
· Colour and Chroma keying
· Motion compensation
· Multistream video
H/W 2D Acceleration of
· BitBlocktransfer
· Line Draw
· Polygon/Rectangle Fill
· Bit Masking
· Monochrome Expansion
· Panning/Scrolling
· Scissoring
· Full ROP support and 64 x 64 x 2 h/w cursor
· Acceleration in 8-32 Bpp modes