FUJITSU ErgoPro m664 - Manual (Page 33)

PC Specialist's Handbook ErgoPro m664-series
Edition 1 - Release 1 - March 1998 Page 3-5
LBA Mode Control
Enables or disables logical block addressing (LBA) in place of the cylinders, heads and sector
fields.
Note: Changing the Changing the LBA Mode Control after a hard drive has been formatted can
corrupt data on the drive.
Disabled
Enabled (default)
Transfer Mode
Specifies method for transferring data between the hard disk and system memory.
Standard
Fast PIO 1
Fast PIO 2
Fast PIO 3
Fast PIO 4
FPIO 3 & Bus Mastering
FPIO 4 & Bus Mastering (default with Ultra DMA/33 IDE HDD)
Ultra DMA
Specifies the Ultra DMA mode for the hard disk.
Disabled (default if not Ultra DMA/33 IDE HDD)
Mode 0
Mode 1
Mode 2 (default with Ultra DMA/33 IDE HDD)
Primary IDE Slave
Reports type of connected IDE device. When selected, displays the following Primary IDE Slave
submenu. Settings of this submenu, see Primary IDE Master submenu settings in this section.
Secondary IDE Master
Reports type of connected IDE device. When selected, displays the following Secondary IDE Master
submenu. Settings of this submenu, see Primary IDE Master submenu settings in this section.
Secondary IDE Slave
Reports type of connected IDE device. When selected, displays the following Secondary IDE Slave
submenu. Settings of this submenu, see Primary IDE Master submenu settings in this section.