FujiFilm 2650 - Manual (Page 54)

106 107
Use only the AC-3V AC Power Adapter (sold
separately) with your FinePix 2650 Digital Camera. The
use of other AC power adapters may result in damage
to your camera.
h This AC power adapter is designed exclusively for
indoor use.
h Plug the connection cord plug securely into the DC
input terminal of the FUJIFILM Digital camera.
h Turn off the power switch of the FUJIFILM Digital
camera before disconnecting the connection cord
from the FUJIFILM Digital camera’s DC input
terminal. To disconnect, take hold of the plug and pull
it out (do not disconnect it by pulling on the cord).
h Do not use this AC power adapter with any device
except the specified device.
h During use, this AC power adapter will become hot to
touch, but this is normal.
h Do not disassemble the AC power adapter. Doing so
could be dangerous.
h Do not use this device in a place with high
temperature and high humidity.
h Do not drop or subject this device to strong shocks.
h This device may emit a humming noise, but this is
normal.
h If used near a radio, this device may cause static, so
play the radio in a distant place.
AC Power Adapter
If any liquid at all leaks from the batteries, wipe the
battery compartment thoroughly and then load new
batteries.
If any battery fluid comes into contact with your
hands or clothing, flush the area thoroughly with
water. Note that battery fluid can cause loss of
eyesight if it gets into your eyes. If this occurs, do not
rub your eyes. Flush the fluid out with clean water
and contact your physician for treatment.
■
Disposing of Batteries
When disposing of batteries, do so in accordance with
your local waste disposal regulations.
■
Notes on Small Rechargeable Batteries (Ni-
MH batteries)
h Always use the special battery charger to charge AA-
size Ni-MH batteries. Charge the batteries as
described in the instructions provided with the battery
charger.
h Do not use the battery charger to charge batteries
other than those specified for use with the charger.
h Note that the batteries may feel warm immediately
after being charged.
h Ni-MH batteries are not charged at shipment. Be sure
to charge the batteries before using them.
h The camera mechanism is such that it draws a
minute amount of current even when the camera is
switched off. Take particular care not to leave Ni-MH
batteries in the camera for a long period of time as
they can become excessively discharged and may no
longer be usable even when charged.
h Ni-MH batteries self-discharge even when not used.
Always charge Ni-MH batteries before using them. If
the time for which a battery provides power shortens
markedly when it has been correctly charged, this
indicates that the battery has reached the end of its
effective life and should be replaced.
h Soil (fingerprints, etc) on the terminals of Ni-MH
batteries can greatly reduce the number of available
shots. When this occurs, clean the terminals carefully
with a soft dry cloth. Then use up the remaining
charge in the batteries and recharge them.
h Newly purchased batteries or batteries that have
been left unused for an extended period may not be
fully charged. (This is indicated by the immediate
display of the battery low warning or a low number of
available shots.) This is a normal characteristic of the
batteries and does not indicate a fault. Repeatedly
charging and using the batteries 3 or 4 times will
restore them to a normal condition.
h If you repeatedly charge a Ni-MH batteries before it is
fully discharged, it will suffer from the “memory
effect”
✽ , causing the battery low warning to appear
while there is still ample charge remaining in the
battery. To restore the batteries to their normal
condition, use up all the charge in the batteries before
recharging them.
Notes on the Power Supply
h Soil (such as fingerprints) on the battery terminals can
markedly reduce the number of available shots.
Carefully wipe the battery terminals clean with a soft dry
cloth before loading the batteries.
✽ Memory effect: A phenomenon affecting the battery
characteristics such that the apparent
battery capacity decreases.