FujiFilm 2650 - Manual (Page 12)

22 23
2
Using the viewfinder or LCD monitor, frame your
shot so that the subject fills the entire AF (Auto
Focus) frame.
●
! If your subject is not in the center of the picture, use
AF/AE lock to take the picture(
➡P.27).
When you are using the viewfinder to take a
picture at a distance of 0.8 m to 1.5 m (2.6 ft. to
4.9 ft.), only the shaded area in the figure is
photographed.
5 6
LCD monitor
AF frame
AF frame
Viewfinder
● ! To frame your shot precisely, you should take the
picture using the LCD monitor.
● ! In some conditions it may be difficult to see your
subject clearly on the LCD monitor, such as in sunny
weather outdoors or when you are shooting dimly lit
scenes. In such situations, use the viewfinder to take
the shot.
● ! The image shown on the LCD monitor before you
take the shot may differ in its brightness, color, etc.
from the image actually recorded. If necessary, play
back the recorded image to check it (
➡P.31).
Ensure that your fingers or the camera strap do
not obscure the lens or flash control sensor.
● ! There may be some unevenness in the brightness at
the lower edge of the LCD monitor. This is normal
and does not indicate a fault. This does not affect
the photographed image.
● ! Check that the lens is clean. If it is dirty, clean the
lens as described on P.104.
● ! If you use the flash in very dusty conditions or when
it is snowing, white dots may appear in the image
due to the flash reflecting off the dust particles or
snowflakes. Try taking the shot with the flash mode
set to Suppressed Flash.
To zoom in on the subject, press “a” ( } TELE).
To zoom out, press “b” ( { WIDE). A “zoom
bar” appears on the LCD monitor when you
zoom in or out.
● Optical zoom focal length (35mm camera
equivalent)
Approx. 38 mm-114 mm (1.5 in. to 4.5 in.)
Maximum zoom scale: 3
×
●
! Zooming stops briefly when the camera switches
between optical zoom and digital zoom (
➡P.29).
3 4 4
Zoom bar
TAKING PICTURES (A AUTO MODE) Q MODE