FujiFilm 2650 - Manual (Page 35)

68 69
5
■ SET–UP Menu Options
Settings Display Explanation
POSTVIEW
USB MODE
POWER SAVE
DATE/TIME
ON/OFF
DSC/PC CAM
ON/OFF
SET
This option specifies whether or not an image checking screen (photography
results) is displayed after you take a shot.
The photography results are displayed for about 2 seconds and then automatically
recorded.
See P.82 for details.
If the camera is not used for approximately 30 seconds, this function temporarily
switches off the LCD monitor. See P.70 for details.
Use this option to correct the date or time. See P.15 for details.
Use this option to specify whether the LCD monitor is automatically switched ON or
OFF when the Mode switch is set to “Q”.
This setting selects the volume of the beep emitted by the camera during camera operation.
This resets all camera settings (including the photography and playback menu
settings) other than the date and time to the factory default values set at shipment.
When you press “c”, a confirmation screen appears. To proceed, press the
“MENU/OK” button again.
Select English, French or German as the language used for screen display.
Factory
default
ON
DSC
ON
—
Q LCD ON/OFF ON
BEEP F LOW/HIGH/OFF LOW
RESET ALL OK —
LANGUAGE
ENGLISH/FRANCAIS/
DEUTSCH
ENGLISH
■ List of settings
A AUTO
S MANUAL
LCD BRIGHTNESS (P.67)
SET–UP
Q Still photography mode
—
—
LCD BRIGHTNESS (P.67)
SET–UP
T Movie mode
—
—
LCD BRIGHTNESS (P.67)
SET–UP
w Playback mode
1Press “a” or “b” to select a menu option and
then press “d” or “c” to change the setting.
2Press the “MENU/OK” button.
You can set the SET–UP in “ Q ”, “ w ” and “ T ”
mode.
1Press the “MENU/OK” button to display the
menu screen.
2Press “d” or “c” to select “ g ” OPTION and
then press “a” or “b” to select “SET–UP”.
3Press the “MENU/OK” button.
● ! Press “c” for “DATE/TIME” or “RESET ALL”.
2 1 0 1
0 2 0 1
0 2 0 3
●
! The figure above shows the screen for still
photography.
g USING SET–UP