Furuno DS-60 - Manual (Page 42)

3. BERTHING DISPLAY
3-12
3.6.2 How to share berthing lines with sub display units
Berthing lines created at the main display unit are automatically sent to all sub display
units that are active when the line is created. To send the berthing lines after a sub
display unit becomes active, do as follows:
1. Press the MENU/ESC key to open the menu.
2. Select [Berthing Line] then press the ENT key.
3. Select [Share] then press the ENT key.
4. Select [Yes] then press the ENT key. All berthing lines in the sub display units are
replaced with the berthing lines from the main display unit.
5. Press the DISP key to close the menu.