FujiFilm DVD-A1XV - Manual (Page 90)

90
Symptom Page Check
An image is not projected with an
HDMI/DVI connection.
25
20~22
63
20~22
57, 58
• Check the HDMI/DVI connection.(Check the status of the HDMI/DVI indicators.)
• Check whether the connected monitor equipment or other equipment supports HDCP. (The
DVD-A1XV will not output a video signal unless the connected equipment supports HDCP.)
• Check the settings of “HDMI/DVI SELECT”.
• Check whether the output format of the DVD-A1XV (HDMI/DVI FORMAT) matches the input
format of the connected equipment.
• Check whether the video output setting at “PURE DIRECT” is set to “VIDEO OUT : OFF”
or “ALL OFF”.
Remote control unit does not operate.
27
27
27
27
27
• Check that the batteries are inserted in the proper “<” and “>” directions.
• The batteries are dead. Replace them with new batteries.
• Point the remote control unit at the remote control sensor when operating it.
• Operate the remote control unit within a distance of 7 meters from the remote control
sensor.
• Remove the obstacle between the remote control unit and remote control sensor.
Menu screen messages for the desired
language do not display. 35~37 • Check the setting of “DISC MENUS” under “LANGUAGE SETUP” in “SETUP”.
Picture and sound are interrupted with
HDMI/DVI connections.
63 • When the “HDMI/DVI FORMAT” setting is set to “AUTO”, the picture or sound may be
interrupted when cables are connected or disconnected or depending on the conditions of
the connected device(s).