FujiFilm DVD-A1XV - Manual (Page 63)

63
PLAY STOP OPEN /CLOSE
DVD AUDIO-VIDEO / SUPER AUDIO CD PLAYER DVD-A1XV
STILL / PAUSE
PURE DIRECT
SELECT
VIDEO MODE
PUSH ENTER
FORMAT SELECT HDMI / DVI SUPER AUDIO CD SET UP
ON / STANDBY
3, 4 1 2
12 USING THE VIDEO SETUP
2 The video output setting of the HDMI and the DVI-D connectors can be changed.
2 The video output setting of the PICTURE MODE, TV SYSTEM, SQUEEZE MODE and AUDIO ADJUST also can be changed.
1
Press the HDMI/DVI SELECT button.
• The modes described below will appear on the display.
HDMI/DVI OFF (Factory default)
Not output via the HDMI and DVI-D connectors. Set to “HDMI/DVI OFF”
when not connecting to these connectors.
HDMI Y Cb Cr
The Y Cb Cr format video signals and audio signals are output via the HDMI
connector.
The RGB format video signals are output via the DVI-D connector.
HDMI RGB
The RGB format video signals and audio signals are output via the HDMI
connector.
The RGB format video signals are output via the DVI-D connector.
✽ When connecting to the DVI device via the HDMI connector, signals are
output in RGB format regardless of whether “HDMI Y Cb Cr” or “HDMI
R G B” is set.
Main unit
SELECT FORMAT
HDMI / DVI
✽ The HDMI and DVI indicators flash when the connection is being checked, then stop flashing, once the check is completed.
HDMI/DVI OFF
HDMI Y Cb Cr
HDMI R G B
SELECT FORMAT NTSC/PAL
AUDIO SUBTITLE ANGLE
HDMI/DVI OPEN/
SUPER AUDIO
CLOSE
CD SETUP
PROGRAM /DIRECT
CLEAR
CALL SEARCH MODE
DISPLAY TOP MENU
BACK LIGHT
POWER OFF POWER ON
1
2
Remote control unit
HDMI/DVI
SELECT FORMAT
Display the setting mode
2
Main unit
SELECT FORMAT
HDMI / DVI
480P/576P
720P
1080i
Remote control unit
HDMI/DVI
SELECT FORMAT
Press the HDMI/DVI FORMAT button.
• The modes described below will appear on the display.
Select the item you wish to set and define it.
480P/576P (Factory default)
Outputs the image via the HDMI or DVI-D connector at 480P or 576P.
720P
Outputs the image via the HDMI or DVI-D connector at 720P.
1080i
Outputs the image via the HDMI or DVI-D connector at 1080i.
AUTO
The performance of the HDMI device connected to the HDMI/DVI-D
connectors is detected automatically and the signals are output according to
the HDMI device’s panel resolution or maximum resolution. The panel
resolution or maximum resolution is selected according to the setting made
at “HDMI AUTO FORMAT” in the initial settings. (By factory default this is
set to “PANEL RES.”. (See pages 38, 41.) ) When a DVI device is connected,
the signals are output with a resolution of “480P/576P” automatically, so set
the resolution manually.
AUTO