Generation ii technical reference – Frymaster LOV M3000 User Manual
Page 40
LOV
™
Generation II Technical Reference
39
Remove this screw that secures the AIF
board to the fryer.
After removing the screw,
the AIF assembly drops
down.
The bottom tab slides
out of the bracket
attached to the frypot.
MIB Replacement
The MIB controller is located inside the left cabinet (see image below). In normal operation, a cover
hides the MIB controls. The LED display is visible.
1. Disconnect the fryer from the electrical
power supply.
2. Remove the three torx screws from the
MIB cover, exposing the MIB board
(see image at right).
3. Remove the screw in the center top
will allow the board to hinge down and
expose the connections on the back of
the board.
4. Disconnect the MIB board by carefully
removing the plugs on the rear of the
board (see image at right).
5. Replace with a new MIB board and
reverse steps to reassemble.
6. Once replaced, reconnect the power.
7. Cycle all power to the unit to readdress
the fryer using the steps on the previous page.
AIF Replacement
The AIF boards are located inside a protective housing underneath each frypot.
1. Disconnect the fryer from the electrical power supply.
2. Locate the AIF board to be replaced under a frypot.
3. Mark and unplug the harnesses.
4. Locate the screw on the front of the AIF assembly holding it in place.
5. Remove the screw and the front of the assembly drops down and the back tab slides out of the
bracket attached to the frypot (see below).
6. Reverse steps to reassemble, ensuring that the new AIF assembly slides into the slot in the
rear of the bracket.
7. Cycle all power to the unit to readdress the fryer using the steps on the previous page.
MIB controller cover (three screws hold it in place).
1 screw
2 screws
Cover