Frymaster LOV M3000 - Manual (Page 26)

LOV ™ Generation II Technical Reference
25
M3000 Useful Codes
To enter any of the following codes: Press and hold and simultaneously for TEN seconds; three
chirps sounds. The computer displays TECH MODE TECH MODE. Enter the codes below to perform this function.
• 0042 0042 – Reset RECOVERY FAULT CALL SERVICE RECOVERY FAULT CALL SERVICE.
• 1658 1658 – Change from F° to C°. The computer displays off off. Turn the computer on and check
temperature to see the temperature scale. If the desired scale is not displayed, repeat.
• 3322 3322 – Reset Factory Menu. The computer displays COMPLETE COMPLETE, and then off off. (NOTE:
This will delete any hand-entered menu items.)
• 1650 1650 – Enter Tech Mode. See page 1-36 to reset passwords and change fi lter pad time.
• 1212 1212 – Switch Between Domestic and International Menu. The computer displays
COMPLETE COMPLETE, and then off off. (NOTE: This will delete any hand-entered menu items.)
• 0469 0469 – Reset Filter Stat Data Filter Stat Data.
The following codes require the removal and reinsertion of the J3 locator plug on the rear of the computer
before entering the code.
• 1000 1000 – Reset CALL TECH CALL TECH Message. Disconnect board locator plug (J10). Reinsert plug.
Enter 1000 1000. Computer display switches to off off. Remove and then restore power to the computer
using the 20-pin plug.
• 9988 9988 – Reset BADCRC BADCRC Message. Disconnect board locator plug (J10). Reinsert plug. Enter
9988 9988. Computer display switches to off off. Remove and then restore power to the computer using
the 20-pin plug. Replace the computer.
The following codes are entered when prompted to do so or from an energy misconfi gured exception error.
• 1111 1111 – Reset SERVICE REQUIRED SERVICE REQUIRED Message. Enter this when the issue is fi xed and you
are prompted to enter.
• 1234 1234 – Enter SETUP MODE SETUP MODE from energy misconfi gured exception error. (This usu-
ally can be done without pressing the fi lter buttons if an error is displayed.)
Passwords
To enter level one, level two passwords – Press and hold the TEMP and INFO buttons simultane-
ously until
level 1 level 1 or level 2 level 2 is displayed. Release the buttons and ENTER ENTER Code Code appears.
• 1234 1234 – Fryer Setup, Level One, and Level Two.
• 4321 4321 – Usage Password.