FUNAI MWR10D6 - Manual (Page 69)

67 EN
Before
you
start
Others
Español
Connections
Getting
started
Recording
Playing
discs
Editing
Changing
the
Setup
menu
Changing the Setup menu
Settings for Dolby Digital (Default : Stream)
Digital Out - Dolby Digital
Stream
PCM
• Using [K / L], select a setting. Press [OK].
Your setting will be activated.
PCM
:Convert the Dolby Digital into PCM (2 channel).
When your amplifier/decoder is NOT compatible with Dolby Digital, set
to “PCM”.
Stream :Outputs Dolby Digital signals
When your amplifier/decoder is compatible with Dolby Digital, set to
“Stream”.
Settings for PCM (Default : 48kHz)
Digital Out - PCM
96kHz
48kHz
• Using [K / L], select a setting. Press [OK].
Your setting will be activated.
48kHz :If your amplifier/decoder is NOT
compatible with 96kHz PCM, select
“48kHz”. 96kHz sound will be output in
48kHz.
96kHz :If your amplifier/decoder is compatible
with 96kHz PCM, select “96kHz”. 96kHz
sound will be output.
B
A
Note
When playing disc with
copyright protection
• Even if you select
“96kHz”, the sound will
be down sampled at
48kHz.
Audio setting (cont’d)
• Using [K / L], select a setting.
Press [OK].
Your setting will be activated.
Dynamic Range Control (Default : ON)
Set to “ON” to compress the range between soft and loud sounds.
4
Press [SETUP] to exit.
Disc Audio
Digital Out
Dynamic Range Conrtol
ON
Dynamic Range Control
OFF
ON
4