High End Systems High End LCD Controller for Studio Color - Manual (Page 80)

3-18 Using the Construct Keys Studio Color LCD Controller
4. Press the key and use the Construct and
arrow keys to select
/
.
5. Use the joystick to direct the beam at a reference point (wall,
screen, or other surface).
6. Press the key, then use the Construct and
arrow keys to select
) )'*
as shown
below:
7. Press the key and use the Construct and
arrow keys to select a value of
5
.
8. Press the key and use the Construct and
arrow keys to select a value of
5
9. The result is a 100% red beam. Press the key and use
the Construct and arrow keys to vary the value
of the construct from 0 to 255. You should see a red beam of
varying intensities.
10. Press the key and use the Construct and
arrow keys to select
) )'*
.
11. Press the key and use the Construct and
arrow keys to vary the value of the construct.
• From 0 to about 122 (48%), the beam rapidly increases in
intensity.
• The beam reaches a minimum intensity at about 140
(55%).
• From about 141 (55%) to 255 (FF%), the beam rapidly
increases in intensity again.
12. With the Red construct at full intensity, try varying the Green
and Blue constructs to see the effect on color mixing.
*
) /
,
/#) )'*-#'