Planar Systems Simplicity Series SLM50 50" UHD 4K Commercial Monitor - Manual (Page 57)

Operating the Display
Planar Simplicity M Series User Manual
020-1409-00D
Page | 57
Power Save Mode

Select the standby behavior of the unit.

Options: Standby Mode, Networked Standby Mode, Wake on Signal, Always On

Default: Standby Mode

Standby Mode: Achieves the lowest standby power consumption and disables LAN and
RS232 functionality while in standby. The Scheduling feature will remain functional.

Networked Standby Mode: Supports waking the unit via Wake-on-LAN (WoL) but
disables RS232 functionality while in standby. The Scheduling feature will remain
functional.

Wake on Signal: The unit will enter a standby mode if no signal is detected. When a
signal is restored, the unit will quickly power on and display the image. This mode
supports the full LAN and RS232 command set while in standby mode.
o Note: Sending an OFF command via Keypad, IR, CEC, RS232 or LAN will
bypass Wake On Signal detection.
o Note: If Failover detection has been enabled, the unit will automatically search
for a signal on other inputs before entering standby.

Always On: This is the fast startup mode. An OFF command sent via Keypad, IR, CEC,
RS232 or LAN will place the unit into a standby mode that enables the fast startup. This
mode supports the full LAN and RS232 command set while in standby mode.

Note: Startup time can be reduced by performing one of the following actions:
o Disable the splash screen (see page 50)
o Select one of the following Power Save Mode settings: Wake on Signal, Always
On. These modes will forcibly set the splash screen to Off
Advanced Settings Reset

Resets all settings in the Advanced Settings menu to their default values