Nissin MG80 Pro Flash for Cameras - Manual (Page 21)

Flash Exposure Control
M manual flash mode power control
TTL memory (exposure value memory)
1. Press Group Selection button, the group letter blinks.
2. Rotate the Operation Dial to increase or decrease the power of the selected group.
The setting of M mode starts from 1/256 (minimum) to 1/1 (Full) and it controlled
by 1/3 step intervals. The value digi displayed next to the group
only shows the integer step value (*).
3. When the M mode setting is completed, press the group selection button again.
Switch the MG80 Pro from TTL mode to M, the last flash power setting
will be saved in TTL control. Flash power value will also remain memorized in M mode.
NOTE
If you do not press any group selection button all group letter will not blink. Rotate
the Operation Dial to increase/ decrease the power of all group. For example, A:
1/256, B: 1/8 + 0.6EV, C: 1/4, D: 1/2, do not select any group then rotate the
Operation Dial clockwise with 2 intervals, it becomes
A: 1/256 + 0.6EV , B: 1/4 + 0.3EV, C: 1/4 + 0.6EV, D: 1/2 + 0.6EV.
(*) The integer step values of Nissin MG80 Pro
1/1, 1/2, 1/4, 1/8, 1/16, 1/32, 1/64, 1/128 and 1/256
B
C
D
A
M mode
20