Nissin MG80 Pro Flash for Cameras - Manual (Page 14)

Commander Mode
NAS
Step 2: Pairing on Nissin MG80 Pro in Commander Mode
1. Press the ON/OFF button to switch on and press the Power button for
3 seconds to select Commander Mode.
2. Turn off the MG80 Pro, hold the Panel Lock key and the ON/OFF button for
3 seconds at the same time. Pilot button will blink about 10 seconds to
process the pairing.
NOTE
For Sony Camera
When usiung MG80 Pro in “Commander” mode, please install MG80 Pro on camera
and change the Flash mode to “WL” in camera menu.
If strobes are still beeping constantly after pairing, which means it is not complete.
Please move your MG80 Pro towards the beeping strobes. Turn off the MG80 Pro
and pair again.
(*) Compatible Channel for NAS System
Nissin Di700A, i60A flash and Nissin Air R receiver do not support the Channel 1 in
Nissin MG80 Pro.
Please use Channel 2 to 8 to pair with those 3 NAS slave unit models.
The default channel setting is no. 2.
If you want to change this setting then press the channel button for 2 second.
Press channel button 2 second to exit setting.
i60A / Di700A / Air R
MG10 / MG8 / MG80 Pro Ch.2 - 8
Ch.1 - 8
Ch.1 - 8
Ch.2 - 8
Ch.1 - 8
Ch.2 - 8
Air1 Air 10s MG80 Pro
13