Nissin MG80 Pro Flash for Cameras - Manual (Page 20)

NOTE
Flash Exposure Control
TTL flash exposure compensation
1. Press Group Selection button, the group letters blink.
2. Rotate the Operation Dial to increase or decrease the TTL flash exposure compensation.
The settings of TTL starts from -2EV to + 2EV and control by 1 / 3EV step interval.
In addition, there is exposure value shown in the bar chart:
Setting of 0EV shows in 0.0,
Setting of -2EV to -0.3EV will be displayed in -2.0 to -0.3;
Setting of +0.3EV to + 2EV will be displayed in 0.3 to 2.0.
3. When the exposure compensation setting completed,
press the group selection button again.
If you do not press any group selection button, all group letter will not blink. Rotate
the Operation Dial to increase/ decrease the power of them groups. For example, A:
0EV, B: + 0.6EV, C: + 1EV, D: -1EV, do not select any group then turn the
Operation Dial clockwise in 2 click intervals, it will cause to A:
+ 0.6EV, B: + 1.3EV, C: 1.6EV, D: -0.3EV.
TTL mode
Switch the MG80 Pro from TTL mode to M, the last flash power setting
will be saved in TTL control. Flash power value will also remain memorized in M mode.
TTL memory (exposure value memory)
19