Nissin MG80 Pro Flash for Cameras - Manual (Page 18)

Group On/off Setting
If you want to change the flash effect of different slave units group, you
can turn on or off the other.
1. Press Group Selection button of MG80 Pro.
Press the “Group ON/OFF” button when the selected group is blinking.
After switched on the group, the value and the bar of exposure setting
will be appeared on the screen. When it switched off, only "---" is shown.
2. Press the “Group Selection” button again when finish setting.
Nissin MG80 Pro Commander Mode
(*)If there are no selected group, press will change status of all groups.
A & C: on, B & D: off A & C: off, B & D: on
17
NOTE
MG80 Pro Commander Mode setting are under Basic Group A. Changing Basic
Group A will affect the On-Camera flash.