Nissin MG80 Pro Flash for Cameras - Manual (Page 13)

Commander Mode
Pairing Setting
Step 1: Switch off all unit
To perform wireless shooting, set the Nissin MG80 Pro as commander and or
NAS slave with the following procedure. When pairing completed, both of them
memorized the data and no need to pair again after switching.
1. Hold the "Set" and Power “ON/OFF” buttons for 3 seconds at the same time.
3. Nissin Di700A will automatically be changed into wireless slave mode
after pairing completed.
Nissin flash Di700A
NAS
2. “Beep” sound persists until the pairing signal received.
2. “Beep” sound persists until the Pairing complete.
Nissin flash i60A
1. Hold the Panel Lock key and the ON/OFF button of Nissin i60A
for 3 seconds at the same time.
1. Rotate "Ch" channel dial to "A" auto channel mode.
3. “Beep” sound persists until the Pairing signal received from commander.
Nissin flash MG10 / MG8
2. Hold "Open" button and the power button for 3 seconds.
1. Switch on MG80 Pro, press Power button for 3 seconds to open mode menu,
select Slave Mode then turn off.
3. “Beep” sound persists until the pairing complete.
Nissin flash MG80 Pro (Slave mode)
2. Hold the Panel Lock key and the ON/OFF button of Nissin MG80 Pro
at the same time for 3 seconds.
Nissin Air R Receiver
1. Rotate "Ch" channel dial to "Auto" auto channel mode.
2. Hold power button for 3 seconds
3. “Beep” sound persists until the pairing complete.
12