Shure AONIC 215 Gen 2 Bluetooth True Wireless In-Ear Headphones (Blue) - Manual (Page 16)

Shure Incorporated
16/20
•
•
•
•
1.
2.
1.
2.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa­
tion. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End user must follow
the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. The portable device is designed to meet the requirements for exposure to
radio waves established by the Federal Communications Commission (USA). These requirements set a SAR limit of 1.6 W/kg
averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use
when properly worn on the head.
This equipment should be installed and operated with minimum distance 0 cm between the radiator and your head.
This device contains licence­exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Develop­
ment Canada’s licence­exempt RSS(s). Operation is subject to the following two conditions:
This device may not cause interference.
This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes :
L’appareil ne doit pas produire de brouillage;
L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment could
be installed and operated with minimum distance 0 cm between the radiator and your body. End user must follow the specific
operating instructions for satisfying RF exposure compliance. This transmitter must not be co­located or operating in conjunc­
tion with any other antenna or transmitter.
The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These require­
ments set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard dur­
ing product certification for use when properly worn on the head.
Cet équipement est conforme aux limites d’exposition aux rayonnements ISED établies pour un environnement non contrôlé.
Cet équipement peut­être installé et utilisé avec une distance minimale de 0 cm entre le radiateur et votre corps. L’utilisateur fi­
nal doit suivre les instructions spécifiques pour satisfaire les normes. Cet émetteur ne doit pas être co-implanté ou fonctionner
en conjonction avec toute autre antenne ou transmetteur.
Le dispositif portatif est conçu pour répondre aux exigences d’exposition aux ondes radio établie par le développement én­
ergétique DURABLE. Ces exigences un SAR limite de 1,6 W/kg enmoyenne pour un gramme de tissu. La valeur SAR la plus
élevée signalée envertu de cette norme lors de la certification de produit à utiliser lorsqu’il est correctement porté sur la tête.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: Testing is based on the use of supplied and recommended cable types. The use of other than shielded (screened) cable types may degrade EMC per­
formance.