Shure i2c-t User Manual

Shure Headphones

Audio source:

cell phone

media player

2c-

Sound Isolating Earphones

These sound-isolating earphones

with VoicePort inline microphone

connect to your integrated media

player cell phone. They feature

Dynamic MicroDriver technology

that you can now enjoy at low

listening levels, even in noisy

environments.

INSERTING THE EARPHONES

If the earphone seems to be lacking in low frequency response (bass), check
the tightness of the seal between the earphone and your ear, or try one of the
other sleeve options.

Warning: Do not push the earphone sleeve beyond the ear canal opening.

WEARING THE EARPHONES

CHOOSING AN EARPHONE SLEEVE

Your earphones come with a selection of sleeves. Make sure the sleeve you
use is easy to insert into your ear, fits comfortably, and is easy to remove from
your ear.

WAX GUARD

You should place wax guards on the nozzle of your I2c-T earphones before
using them. These protective rings are found on an adhesive strip in the fit kit
that comes with your earphones.
To place a wax guard on one of your I2c-T earphones:

Remove the sleeve from the earphone nozzle.
If there is a dirty wax guard on the earphone, peel it off.
Clean the tip of the I2c-T nozzle with an antiseptic or alcohol wipe.
Make sure that the tip of the nozzle is dry, then remove a wax guard from the
supplied strip and place it on the tip of the nozzle, adhesive side down.
Replace the sleeve on the earphone.

1.
2.
3.
4.

Make sure that the sleeve completely
covers the earphone stem. If any part
of the nozzle is exposed, the sleeve is
not properly installed.

Foam Sleeves
When using the foam sleeves, compress the sleeve between
your fingers before inserting it into the ear canal. Hold the
earphone in place for about ten seconds while the foam
expands and creates a tight seal.

Soft Flex Sleeves
In small, medium, and large sizes. Made from pliable rubber.

Stem

Wax Guard

IMPORTANT: Do not place wax guards on sleeves! Wax guards are intended for use on
the tip of the earphone nozzle only. If wax guards are placed on sleeves they will not
function properly and may fall off the sleeves into your ears.

Printed in U.S.A.

Flex Sleeves
In small, medium, and large sizes. Made from translucent
PVC.

Over the ear

in front

left ear

right ear

INLINE SWITCH CONTROL

Push and hold to MUTE cell phone microphone

Volume

Note: Turn volume control to its lowest setting before switching be-
tween music and cell phone. Switching to media during a call mutes
cell phone.

Wear the earphones as illustrated below.