Shure SOUND ISOLATING SE210 - Manual

SE210
Sound Isolating™ Earphones
Combining Hi-Definition
MicroSpeakers and a stylish sound
isolating design to deliver full
range audio free from background
noise, the Shure SE210 is an
ideal portable listening device
upgrade. An included modular
cable and interchangeable Sound
Isolating™ sleeves provide a
comfortable, personalized fit.
The carrying case further
enhances the portability
of these lightweight
earphones.
©2006, Shure Incorporated
27EN3243 (Rev. 2)
Printed in U.S.A.
To replace sleeve, carefully remove old one and slide new sleeve over nozzle
barb. If any part of the nozzle is exposed, sleeve is not properly installed.
Replace sleeves if they do not grip the nozzle tightly
Tighten the cable and take up slack by raising the cable sleeve.
Over the ear
in back
Over the ear
in front
Straight down
in front
Cable
Sleeve
Soft Foam Sleeves
When using the foam sleeves, compress the sleeve
between your fingers before inserting it into the ear canal.
Hold the earphone in place for about ten seconds while the
foam expands and creates a tight seal.
Soft Flex Sleeves
In small, medium, and large sizes.
Made from pliable rubber.
Triple-Flange Sleeves
If desired, the sleeve stem may be shortened. Use sharp
scissors to carefully trim the stem to the desired length.
Note: carefully slide sleeve over earphone nozzle barb for a secure grip.
Grasp the body of earphone and gently twist to remove.
Nozzle
Wire Loop
When cleaning, do not force any object through the earphone
nozzle! This will damage the earphone sound filter.
Cleaning
Tool
Note: Do not pull on cable to remove earphone.
Three suggested methods for wearing the earphones are
illustrated below.
WEARING THE EARPHONES
If the earphone seems to be lacking in low frequency response (bass),
check the tightness of the seal between the earphone and your ear, or
try one of the other sleeve options.
INSER
TING THE EARPHONES
REMOVING THE EARPHONES
Your earphones come with a selection of sleeves. Make sure the sleeve
you choose is easy to insert into your ear, fits comfortably, and is easy
to remove from your ear.
CHOOSING AN EARPHONE SLEEVE
If you notice a change in sound quality, remove the sleeve and check
the nozzle of your earphone. If nozzle is blocked, clear obstruction by
using wire loop end of cleaning tool.
CLEANING THE EARPHONE NOZZLE
Nozzle Barb Sleeve Sleeve Over Barb
Warning: Do not push the earphone sleeve beyond the ear canal opening.