Shure SE110 User Manual

Se110

SE110

Sound Isolating™ Earphones

Balanced MicroSpeakers and a

stylish sound isolating design to

deliver a rich, lifelike listening

experience, the Shure SE110 is

an ideal portable listening device
upgrade. An included modular cable

and interchangeable Sound

Isolating™ sleeves provide a

comfortable, personalized

fit. The carrying case further
enhances the portability of

these lightweight earphones.

Printed in U.S.A.

To change earphone sleeve, twist and pull sleeve to remove it from the nozzle.

Push new sleeve onto nozzle until you feel it slide completely over barb. If any
part of the nozzle is exposed, sleeve is not properly installed. Replace sleeves if
they do not grip the nozzle tightly

Tighten the cable and take up slack by raising the cable sleeve.

Over the ear

in back

Over the ear

in front

Soft Foam Sleeves
When using the foam sleeves, compress the sleeve
between your fingers before inserting it into the ear canal.
Hold the earphone in place for about ten seconds while the
foam expands and creates a tight seal.

Soft Flex Sleeves
In small, medium, and large sizes.
Made from pliable rubber.

Note:

carefully slide sleeve over earphone nozzle barb for a secure grip.

Grasp the body of earphone and gently twist to remove.

Nozzle

Wire Loop

When cleaning, do not force any object through the earphone
nozzle! This will damage the earphone sound filter.

Cleaning

Tool

Note: Do not pull on cable to remove earphone.

Suggested methods for wearing the earphones are
illustrated below.

WEARING THE EARPHONES

If the earphone seems to be lacking in low frequency response (bass),
check the tightness of the seal between the earphone and your ear, or
try one of the other sleeve options.

INSER

TING THE EARPHONES

Nozzle Barb

REMOVING THE EARPHONES

Your earphones come with a selection of sleeves. Make sure the sleeve
you choose is easy to insert into your ear, fits comfortably, and is easy
to remove from your ear.

CHOOSING AN EARPHONE SLEEVE

If you notice a change in sound quality, remove the sleeve and check
the nozzle of your earphone. If nozzle is blocked, clear obstruction by
using wire loop end of cleaning tool.

CLEANING THE EARPHONE NOZZLE

Warning: Do not push the earphone sleeve beyond the ear canal opening.

Nozzle

Barb

Warning: The wax removal loop is only to be used to clean
earphones. Any other use, such as using the tool to clean
ears, could result in injury.

Cable

Sleeve

Straight down

in front