Installation control card – İhlas Aura Cebilon Unique User Manual
Page 22
22
Installation control card
Yes No
Points to Be Checked
O. No
1
Have you measured the amount of chlorine in the mains water?
2
Have you measured the hardness of water?
3
Have you measured the TDS level of water?
4
Have you measured the pressure of water?
5
Is the tank pressure suitable?
6
Have you counselled with the customer for the proper location of the appliance?
7
Has the sealing been ensured for three-way adapter installation in full?
8
Have you counselled with the customer for the faucet mounting hole?
9
Is the driller suitable for the counter material?
10
Is there any suitable plugs for the adapter of the appliance?**
11
Have you checked the chlorine in the membrane inlet after installation?
12
Have you checked clean water/waste water ratio?
13
Have you selected the throttle based on the mains water hardness and have you used siliphos?
14
Have you performed solenoid valve checks?*
15
Have you performed automatic closing valve checks? ***
16
Has the Low Pressure Switch run the pump? **
17
Has the Low Pressure Switch stopped the pump? **
18
Has the High Pressure Switch stopped the pump? **
19
Have you performed leakage checks?
20
Have you operated the pump of the appliance while performing these processes? **
21
Is the connection of waste water hose to the drainage proper?
22
Is the customer informed that they should drain one tank of water?
23
Has the maintenance card filled?
24
Are the required explanations made to the customer?
* Only applies to 101ME.
** Only applies to 101 ME and 101 MD models.
*** Only applies to 101 MD and 101 FG models.
:
...............................
Personnel Performing the Installation
: ........................................................
Date
: ..................................................................
Appliance Serial No