İhlas Aura Cebilon Unique - Manual (Page 12)

12
a
b
• If waste water pipe of the sink
is not a throat hose but a 40
mm plastic pipe, it is mounted
in a 3/8" clamp sealing sponge
affixed state (Figure 7a).
• The flush is drilled from the
hole of the clamp in 8 mm
diameter on the same axis
(Figure 7b). One end of the
3/8" waste water faucet is
connected to this clamp and
the other end is connected to
the 3/8" waste water union.
• If waste water hose will be
mounted on the 50 waste
water installation, a 3/8" clamp
will be mounted and the waste
water hose will be mounted on
its location above this. A seal
must be used when mounting
the adapter to the waste water
installation.
• The adapter is plugged in
after it is placed into the place
where "24 V DC" is written on
the appliance. In this case, it
will not work due to lack of
water and pressure in the
system.**
• Clean water faucet is turned on
• Tank valve must be closed.
• Mains water is supplied to the
system by opening the 1/4 ball
valve (Figure 8). It is seen that
the pump is running.**
• The faucet is closed after a
small amount of water flows
from the clean water faucet.**
• After the operation of the
pump stops, leak test of all the
connections in the system is
performed, the tank valve
opens.
• This system should be used
after the twenty-four hours
washing process, (Installation is
done after this process is
carried out by an authorized
service.)
• After the washing process
since the tank will be filled with
water for the first time. Tank
water is let to flow for no
purpose. Now the appliance is
ready to use.
Waste
Water
Connection
• The appliance is designed for
domestic use. Parts such as
storage tank, waste water hose,
faucet must be attached indoor
environment. Necessary measures
should be taken to prevent
freezing and waste water flow.
• Use the appliance after the
necessary measures are taken in
microbiologically unsafe or disin-
fected waters.
• The appliance must be supplied
with its own power adapter.
• If the appliance will not be used
for a long time (such as more than
1 month), the inlet water valve
must be closed (figure 9), the tank
should be drained and the adapt-
er should be plugged out and the
authorizes service must be called
to disinfect the appliance when
reactivating.
• When there not anyone in the
house, close the water inlet valve
of the appliance for safety
purposes (Figure 8).
• The appliance must not be
interfered for repair and mainte-
nance purposes. Otherwise, it
falls out of the warranty scope,
these operations are carried out
by authorized service.
• As the inlet water temperature
changes, the amount of clean
water to be received and the
efficiency may change. Therefore,
water obtained may be low in
winter and high in summer.
• In any unfavorableness (Figure 8)
close the water inlet valve and
consult authorized service.
Points for
Attention
Pre-tests
** Included in the 101 ME and
101 MD models only.
Figure 8. Mains inlet valve
Figure 7. Waste water connection