IDK VAC-1000HD - Manual (Page 32)

VAC-1000HD User’s Guide
32
7.2.17 [F42] Selecting EDID for WXGA
You can set the number of WXGA pixels based on the resolution setting of EDID.
Setting values
on: 1366×768
oFF: 1360×768 [Default]
Note: This is enabled only if one of 03 to 22 is selected for resolution setting of EDID.
7.2.18 [F60 to F69] Setting output equalizer
Menu numbers
7.2.18 [F60 to F69: OUT1 to OUT10
Setting values
0.0: OFF (No equalization) [Default]
1.5: LOW
3.5: MIDDLE
6.0: HIGH
Notes:
● If you use a 5 m/16.4 feet or longer cable for output, we recommend that you check the configuration with
actual devices in advance, because it largely depends on jitter characteristic of the sink device.
● Set the equalizer value before using the VAC, since the images sometimes are interrupted when the
setting is changed.
7.2.19 [F70 to F79] Setting audio output
You can set whether the audio is turned ON or OFF for each of the HDMI output connectors.
Menu numbers
7.2.19 [F70 to F79: OUT1 to OUT10
Setting values
on: ON [Default]
oFF: OFF