Formax 2200 Series - Manual (Page 97)

Operator's Manua l 2200 Series Fine Adjustments and Corrections
1 7 . FINE ADJUSTMENTS AND CORRECTIONS
Speed of the 2nd
Fold Unit
slow
fast
Fold Lengths Fold variations may occur if the fold plate stops are not set accurately
or if the folding speed is changed.
The fold is off across the entire width of the sheets.
Press key and make the fine adjustment via the menu FOLD LENGTH .
A change in the folding speed also changes the fold length.
Therefore the set-up speed must be maintained.
Skewed Folds Skewed (out-of-square) folds occur when the paper is not fed at right angles with
respect to the fold rollers. This can be corrected as follows:
• Mark the leading edge of a sheet and feed
it through the folder (1).
1
2
• To make the deviation more obvious,
exaggerate the skewed fold by hand (2).
3
• Open the folded sheet and place it in front of the
roller infeed section (3).
• By turning the adjustment wheel on the register table
(4
the register rail must be
adjusted in such a way that the leading edge of the
paper is parallel to the fold rollers.
4
97