Formax 2200 Series - Manual (Page 89)

Operator's Manua l 2200 Series Automatic Setting
Calling up the data for the roller gap must always be done from the main
menu
SET-UP . (F3)
F1 F5 F2
F6
F7
F4
SET-UP
SELECT WITH FUNCTION KEYS
JOB SAVED
———— FOLD ————
ROLLER
GAP DELI-
VERY
SPECIAL STANDARD
SUCTION LENGTH
1. Calling up the menu ROLLER GAP by pressing key F4 .
This should be done, when
-
the set-up was made by entering the fold lengths (special fold)
- the set-up was triggered by marking the fold symbols (standard folds)
2. Calling up the menu JOB SAVED by pressing key F6 .
This applies when
-
the set-up is to be made by recalling a job from the memory
3. Calling up the menu ROLLER GAP by pressing key F8 .
If a different paper is used for the job recalled from the memory,
the data shown in the display cannot be used.
In this case the roller gap must be set via the menu
ROLLER GAP .
F1 F5 F2 F3 F4
1 FOLD UNIT: GAP: 1/1
NOM: 0.10
MANUAL SETTING
ROLLER GAP ( in )
+ - AUTO+ LEARN
--------------- SELECT -------------
ACT: 0.15
In this menu, the roller gap setting can be corrected and displayed.
89
Roller Gap: Three Methods