Formax 2200 Series - Manual (Page 29)

Operator's Manual 2200 Series Register Table
1 0 . REGISTER TABLE
Setting the Format -
Flat Pile Feeder Register rail, ball cage and transport belt form one single
unit and are adjusted together.
1
2
Make sure that the feeder is set to the correct
format. Proceed as follows:
• Loosen the lock screw (1) of the register rail by
turning it counter-clockwise.
• Turn the handwheel (2) until the paper stop pin (3)
just touches the edge of the paper stack.
• Retighten the lock screw (1) by turning it clockwise.
• Set the rear paper support (11) to paper width,
using the scale and pointer.
• Distribute the hold-down bars (5) across the sheet
width. Place one hold-down bar in front of the
suction drum (6).
3
4
5
6
Setting the Format -
Air Feeder • Loosen the lock screw (1) by turning it counter-clockwise.
• Set the alignment rail to the paper size by turning the handwheel (2).
The scale at the fold roller infeed section (7) must show the same number as
the scale on the feeder (8).
9
10
7
11
8
• Tighten the lock screw (1) by turning it clockwise.
• Distribute the hold-down bars (9) across the width of the sheet.
The infeed angle can be changed by means of the knurled screw (10) and the
appropriate scale.
If the paper is less than 15 - 16 cm wide, the paper guide plate (4) must
be removed.
29