Formax 2200 Series - Manual (Page 35)

Operator's Manual 2200 Series Stacker
1 4 . STACKER
8
9
1
13
12
11
14
!
When making or breaking any electrical
connection, always first turn off the main
switch or the safety switch of the folder.
Non-compliance may cause damage to
electronic components!
The
stacker is mobile. The height is adjustable by means of a
gas-filled shock-absorber.
An additional control box (1) allows stopping and starting the machine (2) and
paper feed (3) to facilitate setting the hold-down rollers.
1
4
5
6
7
2
3
Stacker
Setting the Transfer
Height • Loosen the lock screw (4) by
turning it counter-clockwise.
• Lift or lower the delivery table.
• Tighten the lock screw (4) by
turning it clockwise.
Setting the Format
The hold-down rollers (5) are needed for
achieving a clean fanned delivery.
They prevent the folded sheets from
opening up on the delivery belt.
The hold-down rollers are adjustable
in two direction (6, 7).
When moving them sideways make sure that the rollers always run
on a delivery belt.
The distance between delivery shafts (8) and hold-down
roller (9) should correspond to the sheet length of the
folded sheet (10). To adjust, proceed as follows:
• Turn the setting wheel (11) to the left or to the right
and shift the hold-down rollers to their new position.
Pushing the button (12) will move the delivery belts for
easy removal of sample sheets.
The pressure of the hold-down rollers can be changed
by turning the knurled screws (13).
Choose less pressure for thin paper below
20 #
and more pressure for paper above 39 #.
Electrical
Connection The electrical connection of the delivery section is
made by plugging the connecting cable into the
socket (14) in the last fold unit.
35