Formax 2200 Series - Manual (Page 27)

Operator's Manual 2200 Series Flat Pile Feeder
Format setting:
• Move the rear cross-bar (1) (secured with a clamp lever) in such a way that the
sheet stop rods (2) are placed against the left- and right-hand side edge as well
as against the rear edge of the stack.
The weight rods (3)
on the left- and right-
hand side must touch
the corners of the stack.
4 2
2
1
3
2
• Move the lateral cross-bar until the side stop
(4) touches the stack.
• Adjust the air nozzles in such a way that they
are approx. 1 to 2 cm away from the side -
resp. rear edge.
• Adjust the angle of the air flow by turning the
air nozzles so that about 10 sheets are
separated.
1-2 cm
The amount of air can be fine-adjusted by means of valves (5).
5
5
6
The air cushion must not be so strong that the sheets under the suction drum
are compressed.
Place the stop plate on the rear stops (6) so that an air cushion is created.
27