Universal big block mopar carbureted system, Installation instructions, Please read carefully – Paxton Superchargers Universal Big Block Mopar 440 Carbureted System User Manual

Page 6

P/N: 4809662

02NOV10 v2.0

Universal Big Block Mopar

Carbureted System

Installation Instructions

PLEASE READ CAREFULLY

This kit should only be installed by qualified mechanics. It is imperative that the

correct air/fuel mixture be maintained at all times. This kit is to be supplied

to competent engine tuners for their completion by the addition of, and tun-

ing of, an appropriate carburetor unit.
This product is intended for use on healthy, well maintained engines. Installation

on a worn-out or damaged engine is not recommended and may result in failure of

the engine.
Paxton Automotive is not responsible for engine damage. Installation on new

engines will not harm or adversely affect the break-in period so long as factory

break-in procedures are followed.

For best performance and continued durability, please take note of the following key points:

1. Use only premium grade fuel 91 octane or higher (R+M/2).
2. The engine must have stock or lower than stock compression ratio.
3. If the engine has been modified in any way, check with Paxton prior to using this

product.

4. Always listen for any sign of detonation (pinging) and discontinue hard use (no

boost) until problem is resolved.

5. Perform an oil and filter change upon completion of this installation and prior to

operating the vehicle. Thereafter, always use a high grade “SF” rated engine oil or a

high quality synthetic, and change the oil and filter every 3000 miles.

6. Before beginning installation, replace all spark plugs with one to two step colder heat

range and reset timing to no more than 22° total or install a boost retard ignition.

(Always follow the procedures indicated in the factory repair manual.)

TOOL & SUPPLY REQUIREMENTS:

• Factory Repair Manual

• 3/8" Drive and Socket Set: SAE and Metric

• 1/2" Drive and Socket Set: SAE and Metric

• Open End Wrenches: SAE and Metric

• Oil Drain Tools

• SF Rated Quality Engine Oil

• Loctite Sealer #RC-609

• Oil Filter, and Wrench

• Heavy Grease

• Silicone Sealer

• Teflon Paste Sealant

• TAP, 3/8-18 NPT

S U P E R C H A R G