Mounting bracket/supercharger installation – Paxton Superchargers Universal Big Block Mopar 440 Carbureted System User Manual

Page 17

P/N: 4809662

02NOV10 v2.0

Section 5

MOUNTING BRACKET/SUPERCHARGER

INSTALLATION

5.1 MOUNTING BRACKET INSTALLATION

A. Clean the front of the passenger’s side cylin-

der head so that the mounting spacers will sit

flat when installed.

B. Clean the front of the water pump bosses so

the supercharger bracket will mount flat

against the mounting surfaces.

*** NOTE ***

Refer to Fig. 5.1-b for assistance in the next few

steps. DO NOT tighten hardware until all fasteners

and spacers are installed.

C. Locate the mounting bracket assembly
D. Locate the three 3/8-16 x 6.5” bolts, 3/8 AN

washers, cylinder head mounting block,

1.691” spacer, and main supercharger mount-

ing bracket (See Fig. 5.1-a.)

E. Install two of the 6.5” bolts and washers

through the main bracket and then through

the cylinder head mounting block as shown

in Figs 5.1-b, 5.1-c. Make sure the side of

the mounting block with the center tapped

hole faces the rear side of the Main Bracket.

Fig. 5.1-a

Fig. 5.1-b

Fig. 5.1-c