Fig. 5.3-b – Paxton Superchargers Universal Big Block Mopar 440 Carbureted System User Manual
Page 21
13
P/N: 4809662
©2009 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
02NOV10 v2.0
C. Using three M12-1.75 x 20mm and corresponding M12 washers, attach the tensioner plate to the
front of the supercharger head unit. (See Fig 5.3-b.)
D. Locate three 3/8-24 x 2.0” fine thread bolts, one 3/8-16 x 2.5” coarse thread bolt, four 3/8 AN
washers, and four 1.019” spacers. Install 3/8-16 x 2.5” coarse thread bolt and washer through
the tensioner plate, through 1.019” spacer, through main bracket into threaded hole of the cylin-
der head mounting block. Install the remining 3/8-24 x 2.0” fine thread bolts and washers
through the tensioner plate, through 1.019” spacers and into the threaded inserts pressed into the
rear of the main bracket. Tighten all hardware installed at this time making sure that the ten-
sioner plate is seated evenly between all surfaces.
Fig. 5.3-b