Lingenfelter L460111410 Lingenfelter Camaro SS Boost A Pump 2010-2014 v1.2 - Manual (Page 8)

Page 7.
20. Strip the end of the BAP power wire,
approximately 1/4”-3/8” down.Insert the
stripped wire through one of the holes on the
in-line fuse connector.
19. Run the BAP power wire along the factory
wiring harness as shown, and cut to length at
the new fuse holder location. Save the wire
that is removed.
17. Install the ground wire running off of the
BAP module to the factory ground located to
the right of the fuse box.
18. This picture shows the recomended
mounting location, for the LPE supplied fuse
holder.