Lingenfelter L460111410 Lingenfelter Camaro SS Boost A Pump 2010-2014 v1.2 - Manual (Page 4)

Page 3.
4. Cut the power wire in the position
indicated. Be sure to cut between the BAP
module and as close to the fuse holder as
shown. This is the battery feed wire for the
BAP
3. Raise the vehicle with a vehicle hoist or
a jack and jackstands. Be careful to follow
the GM lifting procedures on the 2010-2013
Camaro due to the aerodynamic components
being easily damaged and the low ride height
of the vehicle. Refer to your owner’s manual
for correct vehicle lifting procedures.
1. Disconnect your negative battery terminal
located in the trunk of the car after removing
the trunk carpet lining.
2. Open the hood of the vehicle. If you have
been driving the vehicle, allow the vehicle to
cool down for a few hours before starting this
installation.