Lingenfelter L460111410 Lingenfelter Camaro SS Boost A Pump 2010-2014 v1.2 - Manual (Page 6)

Page 5.
12. Place the module, as shown inside the
right rear fender well inside the trunk, for
a test fit. Once a good location has been
identified, remove the tape backing and
mount the BAP in place.
11. Install the supplied Velcro as shown on
the back of the BAP module. You will need to
cut the Velcro to length, then press the pieces
together. Remove the backing from one half
and attach it to the BAP module.
9. Slide the side plate up and guide the
spliced wires through the side plate.
10. Tuck the spliced wires down and re-install
the side plate enclosing the spliced wires.
With this set up you can expect upto 17 volts
when activated