Lingenfelter L380xx1410 Lingenfelter Camaro Cast 241 MM Aluminum Differential 2010-12 v1.9 User Manual

Page 7

Page

12. The pull the exhaust barbs from the rubber

exhaust holders shown. You may need a pry

tool to do this but be careful not to damage the

rubber holders. There are two (2) more rubber

holders on the top side of the mufflers, one on

each side of the vehicle. Use the same process

to free the exhaust from them.

13. Remove the chassis stiffening bracket by

removing the four (4) bolts shown. Convertibles

will require you to remove the forward chassis

stiffening bracket as well (8 bolts).

14. Remove the propeller shaft (a.k.a.

driveshaft). This is done using an E18 inverted

Torx socket and a 18mm socket for the front

mounting bolts. The front and rear of the

propeller shaft are removed using the same

process and the same tools. You will also need

to unbolt the center carrier bearing bracket that

supports the driveshaft in the middle.

15. Remove the two (2) 10 mm mounting nuts

holding the front heat shield in place.