Anritsu MP1777A - Manual (Page 58)

5.1 Common IEEE488.2
*RCL Recall Command
Parameter
Function
Example of use
Oto 10
Calls the memory of a specified number and, by doing so, returns the device to the previous
state.
There is no limit to the state to be loaded. See the Table 7-1 in the Section 7.5 "Parameter".
As an SCPI command which has the same function, : SYSTem : MEMory : RECall is avail­
able.
Calls the information stored in memory number 1 and performs setting.
> *RCL 1
*OPT? Option Identification Quet 7
Response
Function
Example of use
Characters to correspond to the option or unit
Option Character
Interface (Bit Rate) selection condition option
Standard
• 2,488 M, 4,977 M, 9,953 M
OPTO
Interface (Bit Rate) selection condition option
Option 01
• 2,494 M, 4,988 M, 9,977 M
OPTI
Interface (Bit Rate) selection condition option
Option 02
• 2,666 M, 5,332 M, 10,644 M
OPT2
Interface (Bit Rate) selection condition option
Option 04
• 3,062 M, 6,125 M, 12,249 M
OPT4
Interface (Bit Rate) selection condition option
Option 05
• 3,069 M, 6,138 M, 12,276 M
OPT5
Interface (Bit Rate) selection condition option
Option 06
• 2,677 M, 5,355 M, 10,709 M
OPT6
Interface (Bit Rate) selection condition option
Option 07
• 2,578 M, 5,156 M, 10,313 M
OPT7
Reports on the list of options and units mounted.
Reports on options and units mounted all delimited by a comma.
Options 01 and 02 are mounted.
> *OPT?
< OPTl, OPT2
5-7
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com