Interlogix Simon XT Tabletop User Manual - Manual (Page 28)

22 Simon XT TableTop Control Panel User Manual
Status beeps
The panel sounds status beeps to alert you to various system events and
conditions (see Table 7 below).
Note: You may receive a different number of status beeps if you press the
buttons quickly.
Table 7: Status beeps
Activity Beep response
Doors+Windows Exit delay and Entry delay beeps sound two times every five seconds and two
times per second during the last ten seconds. If silent exit is used, the exit
delay beeps will only sound twice when you arm and twice when the exit delay
expires.
Motions Exit delay and Entry delay beeps sound three times every five seconds and
three times per second during the last ten seconds. If silent exit is used, the
exit delay beeps will only sound three times when you arm and three times
when the exit delay expires.
Doors+Windows
and Motions Exit delay and Entry delay beeps sound four times every five seconds and
four times per second during the last ten seconds. If silent exit is used, the exit
delay beeps will only sound four times when you arm and four times when the
exit delay expires.
Disarm One beep.
Chime Two beeps.
Special chime Three beeps.
Trouble beeps Six beeps every minute. Press Status to stop beeps for four hours.
No activity beeps Twenty beeps every minute for five minutes. Feature must be programmed by
the installer.
Alarm sirens and lamp modules
Exterior and interior sirens make three different alarm sounds on the premises,
each indicating a different type of alarm. Sirens are programmed by the installer
to time out and stop sounding after a specified time.
Use Table 8 below to understand the siren sounds used by the security system.
Table 8: Alarm siren and X10 light information
Activity Beep response Beep response Beep response
X10 lights Steady Flashing Steady
X10 siren
a
Steady Steady Alarm beeps