Brother FAX-2000P - Manual (Page 82)

Using the Brother FAX Telephone
Making a Call
Lift the handset or press DIAL.
The ON HOOK light will turn on if DIAL is pressed.
Telephone
2
Dial the telephone number using keypad dialing, one-
touch dialing or abbreviated dialing.
When you dial the number after pressing DIAL, lift the
handset if the other party’s voice is heard from the built-in
speaker. If the other party does not answer, press DIAL
again to disconnect the line.
Answering a Call
Lift the handset if your Brother FAX continues ringing. Return the handset
to the cradle after completing a conversation.
Placing a Call on Hold
To place a call on hold after being connected to the other party, press
HOLD. The HOLD light will turn on. To re-connect the line, press HOLD
again.
Hold-melody On/Off
Hold-melody can be enabled or disabled in the setting menu.
FUNCTION, 0, 9, ENTER, 0, 4, ENTER.
Pulse/Tone Switching
You can output tone signals after being connected to the other party
even if your Brother FAX is on a pulse signal line. Press TONE after
dialing. LCD shows to indicate that the signal type has been
switched from pulse to tone.
External Telephone Connection
If you wish to use an external telephone, connect the telephone to
PHONE 2 Jack and set the connection mode. Refer to “Telephone
Answering System Connection” for the setting procedure.
70