Brother FAX-2000P - Manual (Page 118)

Setting ECM
In the ECM (Error Correction Mode), the transmitting side sends a page in
several separate frames. If some of these frames cannot be transmitted
properly due to impairment of the telephone line, the transmitting side re­
sends the failed frames. Consequently, facsimile communication can be
performed with good image quality. Since the ECM transmission may
require re-sending the same data, overall communication time is likely to
take longer than transmission without ECM.
The FAX-2000P can be set to ECM On/Off, separately, for transmission
and reception.
• Even if you set your FAX to ECM On, the communication will be
made without ECM when the other party does not have an ECM
function.
• If memory is inadequate due to memory-transmission use, etc.,
ECM cannot be set to On.
In standby mode, press FUNCTION, 1,1 and ENTER.
1 1 . E r r o r C o r r e c t i o n
0 1 - 1 2 E n t e r / S e l e c t
E C M T x O f f
E n t e r / S e l e c t
2 Specify ECM On/Off for transmission. Select On or Off
using the SELECT key, then press ENTER.
E C M R x O f f
E n t e r / S e l e c t
Specify ECM On/Off for reception. Select On or Off using
the SELECT key, then press ENTER.
The maximum number of pages to be stored in
memory varies with the ECM setting
ECM Off............ Approx. 32 sheets (512K)
ECM On.............Approx. 28 sheets (512K)
106